BARIX Streaming Client Manual de usuario descargar pdf (Pagina 27)

4 Reverting to factory defaults

Click the button.

Click on the button to enter the defaults page.

You will see the following screen:

Click on “Factory defaults” to revert all settings except “Network conﬁguration” to factory defaults.

While restarting the device the following screen appears showing a number counting down:

Upon start up the following screen appears stating the successful reverting to factory defaults:

Hard default settings

To revert all settings (including the network settings) to factory defaults the “Reset” button has to

be pressed for about 5 seconds while the Barix Instreamer is powered.

Note: Use this method if a connection to the Barix Instreamer cannot be established.

This can happen if you once have set a SonicIP address, switched off “SonicIP” and then forgotten

the IP address.

The Hard default settings sets the IP Address to automatic discovery (0.0.0.0) and enables SonicIP.

If this fails we recommend to download the “Instreamer Rescue Kit” from www.barix.com.

Unzip the Kit and read “readme1st.txt” for instructions.

This Rescue Kit reloads the entire ﬁrmware, resets the device to factory default settings using the

supplied serial cable and a PC running Windows 2000, Windows XP or Linux.

27 Reverting to factory defaults

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34 35

Sin comentarios

BARIX Streaming Client Manual de usuario Pagina 27