BARIX Streaming Client Manual de usuario descargar pdf (Pagina 16)

upon the state of the GPI conﬁgured as the Control GPI

Control GPI

Deﬁnes which GPI will control the streaming if the streaming mode is “send on I/O”.

Active open/closed

Deﬁnes whether the device streams when the selected Control GPI is in the open or closed state.

Send Contact Closure Information

The current state of the device's GPI is inserted into RTP and Shoutcast streams. (This also applies

to the BRTP connection type which uses an RTP stream). This feature is compatible with

Streaming Client v02.10 and later.

Trigger level

The Trigger level is only used when Streaming mode is set to send on Level.

Select a value between 0 and 32767.

Open the Device status page and look for the Input peak

value to get a hint for the trigger value. This page refreshes itself every few seconds.

Pre Trigger Start

Pre Trigger Start can be adjusted to prevent a cut off when audio should be sent earlier than

detected. It deﬁnes the amount of time that will be streamed before the actual trigger occurred.

This feature is most useful when used in combination with the send on level feature.

Post Trigger Play

Post Trigger Play can be adjusted to prevent a cut off when audio should be sent longer than

detected. It deﬁnes the amount of time that the device will continue streaming after the actual

trigger has been cleared. This feature is most useful when used in combination with the send on

level feature.

Buffer Underrun Mode (TCP)

The Buffer Underrun Mode (TCP) deﬁnes the action if a TCP stream is slower than the real stream

from the encoder. In this case the output streaming buffer underruns and cannot hold older data

any more. The device can then “disconnect” the TCP connection or it can ”skip” the stream directly

to the encoder stream without disconnecting TCP.

Streaming Packet Strategy

The Streaming Strategy deﬁnes how a packet is build and sent. On “lowest latency” the encoded

data will be sent directly after the encoding. On “optimal package” the packet will be ﬁlled up

before sending.

UDP Tx Source Port

This setting is only used with a custom software application. Enter the used source port number for

a UDP stream (between 0 and 65535). When set to 0 the source port is set to the same port as

selected in the destination port (in section Stream to). If destination isset to “origin source” the UDP

16 Device Conﬁguration

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 34 35

Sin comentarios

BARIX Streaming Client Manual de usuario Pagina 16