BARIX Instreamer Manual de usuario descargar pdf (Pagina 33)

User Manual “Instreamer“ - V4.03 - 24th October 2013

Streaming mode

Streaming is started depending on the selected

operating mode:

• send always will stream always

• send on CTS will stream if the SEND button

(command) is pressed or CTS (Pin 8 Serial

connector) is connected to a positive supply

(9VDC, Pin 4 Serial connector)

• send on Level will stream if the incoming

analogue audio signal is above the Trigger level

(see section below). This feature is not available

for digital inputs.

• send on I/O (only available on devices with GPI)

will stream audio depending upon the state of the

GPI configured as the Control GPI

• For send on CTS, send on I/O or send on Level,

streaming can also be controlled via the SEND

and STOP buttons on the HOME page.

Default setting is

"send on CTS"

Trigger level

The Trigger level is only used when Streaming mode

is set to send on Level.

Select a value between 0 and 32767.

Open the Device status page and look for the Input

peak value to get a hint for the trigger value. This

page refreshes itself every few seconds.

Pre Trigger Start

PreTrigger Start is only used when Streaming mode

is set to send on Level.

PreTrigger Start can be adjusted to prevent a cut off

when audio should be sent earlier than detected. It

defines the amount of time that will be streamed

before the actual trigger occurred.

BARIX AG | 28. Jan. 2014 | Device Configuration | 33 /63

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 62 63

Sin comentarios

BARIX Instreamer Manual de usuario Pagina 33