BARIX Instreamer Manual de usuario descargar pdf (Pagina 20)

Barix Instreamer User Manual Version 01.03

Page 18

10.2 Network configuration using

Telnet

STEP 1

Unplug the power supply of the Barix Instreamer.

STEP 2

Keep the Reset button pushed and plug in the power

supply. Release the Reset button after 5 seconds.

STEP 3

Run a command session. Type telnet with the IP address

announced by SonicIP on port 9999.

Example: telnet 192.168.0.168 9999

You will see the following screen:

Hit <enter> to access the Barix Instreamer in the setup

mode.

STEP 4

Type in <0> and hit <enter> to enter the Network

configuration. Enter all requested values.

STEP 5

Type in <9> and hit <enter> to save the Network

configuration.

10.3 Control APIs for serial and

Ethernet

For integration of the Barix Instreamer into various control

applications and home automation systems, Barix has

developed a control API (Application Protocol Interface)

for the serial port and Ethernet UDP and TCP control.

Serial Port control API

The serial port on the Barix Instreamer can be used to

send control commands from a home automation system

and other PC or embedded applications. In the device

configuration the serial port can be adjusted to suit your

application.

For a detailed list of serial commands refer to the Barix

Instreamer Technical Documentation available on the Barix

website www.barix.com

Ethernet UDP or TCP control commands

The same control commands used on the serial port can be

used as UDP or TCP commands over Ethernet.

For more information and a detailed list of UDP and TCP

control commands refer to the Barix Instreamer Technical

Documentation available on www.barix.com

10.4 Automatic discovery settings

The automatic discovery functions are not executed if a

static IP address is set. To enable automatic discovery but

disable certain IP discovery functions set all but the third

value to zero. For each function you want to disable add

the value from the table below:

 0.0.1.0 to disable AutoIP

 0.0.2.0 to disable BOOTP

 0.0.4.0 to disable DHCP

 0.0.8.0 to disable IPzator

Example: 0.0.3.0 disables AutoIP and BOOTP

0.0.11.0 disables all but DHCP

Warning:

0.0.15.0 disables all discovery functions which locks you out

unless you reset the device to factory defaults by pressing

the reset button for about 5 seconds.

1 2 ... 15 16 17 18 19 20 21 22 23

Comentarios a estos manuales

Sin comentarios

BARIX Instreamer Manual de usuario Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Redes BARIX Instreamer