BARIX Instreamer Manual de usuario descargar pdf (Pagina 15)

Barix Instreamer User Manual Version 01.03

Page 13

7.9 Reverting to factory defaults

Click on the DEFAULTS button to enter the defaults page.

You will see the following screen:

Click on "Factory defaults" to revert all settings except

"Network configuration" to factory defaults.

While restarting the device the following screen appears

showing a number counting down:

Upon start up the following screen appears stating the

successful reverting to factory defaults:

Hard default settings

To revert all settings (including the network settings) to

factory defaults the Reset button has to be pressed for

about 5 seconds while the Barix Instreamer is powered.

Important note

Use this method if a connection to the Barix Instreamer

cannot be established.

This can happen if you have set once a Static IP address,

switched off SonicIP and then forgotten the IP address.

The Hard default settings sets the IP Address to automatic

discovery (0.0.0.0) and enables SonicIP

.If this fails we recommend to download the Barix

Instreamer Rescue Kit from www.barix.com

Unzip the Kit and read "readme1st.txt" for instructions.

This Rescue Kit reloads the entire firmware, resets the

device to factory default settings using the supplied serial

cable and a PC running W2K or XP.

7.10 Rebooting the device

Click on the REBOOT button to enter the reboot page.

You will see the following screen:

Click "Reboot the device" to restart the Barix Instreamer.

While restarting the device the following screen appears

showing a number counting down:

Upon start up the following screen appears stating the

successful restart:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Sin comentarios

BARIX Instreamer Manual de usuario Pagina 15